<menu id="wgm60"><u id="wgm60"></u></menu>
  • <input id="wgm60"></input>
  • <menu id="wgm60"><acronym id="wgm60"></acronym></menu><menu id="wgm60"></menu>
    <input id="wgm60"></input>
  • <input id="wgm60"><u id="wgm60"></u></input>
  • <object id="wgm60"><u id="wgm60"></u></object>
  • <input id="wgm60"></input><input id="wgm60"></input>
    <input id="wgm60"><u id="wgm60"></u></input>

    Features

    • Adjust centerline height simply with a wrench
    1Adjust centerline height easily
    • Eliminate center boss on end faces
    • Provide constant OD dimension
    • Adjust easily in machine

    DS-ACH Toolholders

    2Optimized design reduces vibration
    Good chip control
    DS-ACH type Conventional type
    DS-ACH type Conventional type
    Excellent surface Chattered
    Tested cutting conditions (304 SS)

    Work material : 304 SS
    Holder : DS-SDUL19-11-ACH
    Insert : DCGT32.508MCL TM4
    Cutting condition : 250 SFM .002 IPR .079" DOC?WET

    Tested cutting conditions (304 SS)

    How to use

    Insert moves in an upward direction only. (Loosen wedge screw before making any adjustment)

    How to use

    ① Install the holder slightly below centerline. Then take a facing test cut.

    How to use

    ② Measure the diameter of the centerboss.

    How to use

    ③ aise the center height by one half of the diameter of the boss.
    ?Adjustment references are available in the tool case.

    How to use

    ④ Re-machine the end face.

    *A combination of single-blade type endmills and inserts with center blade is required

    <menu id="wgm60"><u id="wgm60"></u></menu>
  • <input id="wgm60"></input>
  • <menu id="wgm60"><acronym id="wgm60"></acronym></menu><menu id="wgm60"></menu>
    <input id="wgm60"></input>
  • <input id="wgm60"><u id="wgm60"></u></input>
  • <object id="wgm60"><u id="wgm60"></u></object>
  • <input id="wgm60"></input><input id="wgm60"></input>
    <input id="wgm60"><u id="wgm60"></u></input>
    下载南京麻将